In cases where there are multiple hot water outlets that require hot water to be discharged, several tees should be installed at the hot water outlet end of the water heater. If it is a newly renovated house, a water and electricity installation worker can be asked to embed concealed pipes in the wall. If it is an old house, the requirements are not high, and exposed pipes can also be installed.

After installing the three-way valve, hot water can be diverted to areas where it is needed, including the kitchen, washbasin, and other areas that require hot water! As for the need to use a hot and cold faucet to control the start of the water heater, as long as you power on (or battery) and ventilate, open the faucet at any hot water outlet, and the gas water heater will automatically start.

As for installing a mixing valve, it is not contradictory to the water heater. The mixing valve has two interfaces, with the left side connected to hot water and the right side connected to cold water (there is actually no distinction between left and right, only habit). After installation, tilt the mixing valve to the hot water end (left side) to start the water heater! If it's hot, just turn right a little more and you'll be fine.

The most common reason for this situation is that the water pressure is relatively low. At the moment when the cold water faucet is opened, the impact water pressure fluctuation of the pipeline is relatively large, causing the gas water heater in the forest to falsely start once. Due to the short time, it is basically not possible to even start the fire. Just the fan whirs and rotates, and it will be fine. If this situation does not need to be repaired, but if it is more troublesome, the inlet valve under the water heater can be closed. If there is no valve, it is recommended to install one.

Article source: Kaiping water heater faucet& Nbsp& Nbsp& Nbsp& Nbsp& Nbsp& Nbsp& Nbsp& Nbsp& Nbsp;http://www.kplongyi.com/