The reason for the small water output of the faucet

1. Water quality issues, such as clogging of faucets with impurities such as sand, stones, and rust in the water. You can unscrew the water outlet of the faucet for inspection, and drain the water with the filter head removed. Assuming the water flow returns to normal, the problem lies in the filter screen. Then quietly tap the removed faucet filter in the pool, and large solid impurities such as sand will naturally fall down. Remember not to pick it with your hands, as it may push sand into the filter and get stuck. To ensure proper cleaning, the filter and gasket inside can be removed and rinsed. The stain in the center of the filter hole can also be punctured with a needle. After cleaning everything, install it from the beginning. You can learn from faucet manufacturers like these. Many times, if you wholesale faucets, you can go underground and practice with faucet manufacturers.

2. There is another situation introduced by the faucet manufacturer, assuming it is caused by a large foreign object. This situation is relatively rare, but it is also inevitable to encounter it. In fact, it is very simple, just prepare the wrench to open the faucet. Use a wrench to open the interface under the basin. In fact, most faucets can be twisted open with strong force by hand, and the faucet can be removed. Of course, the front filter head also needs to be removed and placed aside. Invert the faucet and pour a bottle of clean water into it. Assuming that the water flowing out from the back is not smooth, it indicates that there is a foreign object inside the faucet tube. It can also be washed underwater to ensure proper cleaning. Then you can reinstall it again. Pay attention to checking whether the connection is tightened during reinstallation to avoid water leakage.

3. The water outlet of the faucet is bifurcated or the water volume is reduced, without bubbles, and the filter screen of the bubbler is blocked by scale or sundries (the bubbler is a complete structure of the faucet outlet, which is used to foam the water flowing from the faucet through the faucet). The solution is to remove the water outlet nozzle and clean the filter screen.

4. The water output of the showerhead is small, the water is forked, the water pressure is low, or there are debris blocking the showerhead. The solution is to unscrew the showerhead and remove the rubber gasket with a filter at the showerhead inlet, or clean the top spray of the showerhead.

5. The basin faucet and kitchen faucet have low water output and do not produce bubbles. Low water pressure prevents the bubbler from producing bubbles. The solution is to remove the faucet and nozzle and replace them with a bubbler.

What to do if the faucet has a small water outlet

1. Turn off the faucet outlet and check and organize it. Check if the water outlet has recovered during installation.

2. Check the connection between the faucet and the hose. Some faucets have installed filter screens to prevent sand from entering, which can cause blockage due to intercepting many debris.

3. Gently tap the filter of the faucet in the water a few times, and sand and other debris will naturally fall. After flushing, install it as it is.

4. Be careful not to use your hands to pick at the faucet filter! This will push the sand into the filter and get stuck! Also, don't wash away the rubber mat!

文章源自：开平开水器龙头            http://www.kplongyi.com/